Проблемы с сетью после обновления системы

Вчера обновил систему, после этого начал чистить старые конфиги и похоже что-то
испортил. Сеть (eth0 и lo) не поднимаются при загрузке. Вывод rc скриптов
* Starting lo
* iproute2 does not support the required function provides

* Starting eth0
* Loading networking modules for eth0
* adsl does not support the required function provides
* apipa does not support the required function check_installed
* arping does not support the required function provides
* bonding does not support the required function provides
* bridge does not support the required function provides
* dhclient does not support the required function provides
* dhcpcd does not support the required function provides
* essidnet does not support the required function check_installed
* ifconfig does not support the required function provides
* ifplugd does not support the required function provides
* ip6to4 does not support the required function check_installed
* ipppd does not support the required function provides
* iproute2 does not support the required function provides
* iptunnel does not support the required function check_installed
* iwconfig does not support the required function provides
* macchanger does not support the required function check_installed
* macnet does not support the required function check_installed
* netplugd does not support the required function provides
* pppd does not support the required function provides
* pump does not support the required function provides
* rename does not support the required function check_installed
* system does not support the required function check_installed
* tuntap does not support the required function provides
* udhcpc does not support the required function provides
* vlan does not support the required function provides
* wpa_supplicant does not support the required function provides
* modules:
* no interface module has been loaded

Конфиг /etc/conf.d/net
config_eth0=( "dhcp" )

При этом моя сетевуха в системе видна и после запуска dhcpcd и ipconfig eth0 up сетевуха нормально получает адрес. Если кто-нибудь с этим сталкивался, подскажите в какую сторону копать
Спасибо